1, Steel-plastic composite grating tensile force by the weft and braided high strength steel wire to bear, in the low strain capacity to produce very high tensile modulus, longitudinal and transverse ribs synergistic effect, give full play to the grating on the soil body embedded lock effect.

2, Steel-plastic composite geogrid longitudinal and transverse ribs of steel wire weaving into a network, the outer parcel layer of one-time molding, steel wire and the outer parcel layer can coordinate the role of the destruction of the elongation is very low (not more than 3%). Steel-plastic composite geogrid main force unit for steel wire, creep is very low.

3, Through the production process of plastic surface treatment, suppression has a rough pattern, in order to enhance the grating surface roughness, improve the steel-plastic composite geogrid and soil friction coefficient.

4, The width of steel-plastic composite geogrid can be up to 6m, which can realize efficient and economical reinforcing effect.

5,Steel-plastic composite geogrid adopts high-density polyethylene to ensure that: it will not be eroded by acid, alkali and salt solution, or oil at room temperature; it will not be attacked by water dissolution or microorganisms. At the same time, polyethylene polymer performance is also enough to resist the aging caused by ultraviolet radiation. Grating force after the vertical and horizontal ribs synergistic action, will not produce the knot of the pull crack or breakage. In the actual project, after the compaction of the filler, it is therefore not subjected to ultraviolet light and oxygen erosion, and therefore fully meets the requirements of permanent engineering construction.

1, Geogrid paving surface should be relatively flat, paving layer after acceptance, in order to prevent longitudinal skew phenomenon, first according to the width of the paving layer in the white line or hanging line, you can start paving, and then use the U-type nails to fix the end of the grating (4 nails per meter wide, even distance fixed).

2, After fixing the end of the grille, with the paving machine or artificial method will slowly pull the grille forward to pave, every paving 10 meters long for artificial straightening once, until a volume of grille paved, and then pave the next volume, the operation of the same as before.

3, Paving: volume length as a unit as paving section length, should be paved grating section length after paving, and then check the quality of paving as a whole, and then proceed to pave the next section.

4, The next section of paving, grating and grating to overlap a net distance of the grid for the lap length, and fixed with a tie line to continue to pave the second section in the forward direction. And so on, the operation requirements with the previous.